Maytag Neptune repair:
Another Neptuner needs help... Here is a question from a Neptuner that was pulled from the blogosphere...
Q: Last night, I washed some clothes with two pillows. It seems that the pillows were rubbing against the seal? (The plastic thing next to the door) and now that the seal has a hole. There is great but I will not wash until you know if that is really bad (maybe the water can get in there). Also, I think because of that the washer was making a really loud noise near the end of the cycle.
A: If the bearings are going out you can replace them. See Neptune Bearing for more info. You can also rent a special tool kit, too. Usually, the machine will start to sound like a jet taking off when in the high speed spin cycle.
If you call a tech and the bearings need attention, they will ask for $900 to replace the outer tub, unless they are a tech that owns the Neptune Bearing Tony Tool from Neptune Kits then you might get the bearings replaced for $200 or so.
It is also possible the spinner support has an issue and is causing the inner tub to wobble which can rub the plastic liner. Contact me and I can get you a new spinner support which comes with the new seal.
Until next time...
No comments:
Post a Comment