Symptoms for Anxiety are many

Symptoms for Anxiety

Recently, I had a relative experience a panic attack so I researched what symptoms you can expect and was quite surprised at how many there were...

Here is the link to the blog I put up on Symptoms for Anxiety

Now if you have a Maytag Neptune Front Loader with the timer knob (non digital) then you may experience some of these symptoms when your door latch wax motor melts your control board's R11 resistor and the Q6 triac. See Neptune Help for more information...

Until next time...

Maytag Neptune Question about the W10181639 Spinner Support

Hi Neptuner!

Here is a Maytag Neptune Spinner Support question that I received lately...

"I have a spinner support with a broken bolt stud. Can you replace the bolt studs in the spinner support, or do you have to replace the entire spinner support? If I have to replace the spinner support, do you have them and what does it cost? I will also replace the bearing and seal when I fix the spinner support."

A: I've had Neptuners successfully replace a broken stud on the spinner supports. You will want stainless steel replacement hardware. Sometimes the end of the spinner support arm corroded away and the spinner support needed replaced. You can order a new Neptune spinner support at w10181639.com. Note: I have a photo of a brand spankin' new spinner support above...

In addition, the new spinner support comes with the revised lip seal, too. So if you're replacing your bearings you can get a $40 refund if you purchased bearings from Neptune Bearing or even rented the Neptune bearing tool kit which almost pays for half of the new spinner support! Please don't open the 12002022 seal kit... just send it back for your $40 refund...

Don't forget to replace your 12002535 door latch wax motor if you have an earlier timer version (non digital) Neptune front loader with the original one still in it before it chokes and smokes your machine control board. See Neptune Help for more information.

Until next time...