Maytag Neptune Washer - Bearing Spacer Question:
I've been asked a few times lately regarding the installation of the new bearing spacer so I wanted to post the answer here. If you will look at the picture you will notice one end of the spacer is flat and the other end has a slight bevel.
The beveled end goes towards the rear of washer because you don't want the spacer rubbing the seal on the rear bearing.
If you have a Maytag Neptune front load washer check out Maytag Neptune Bearing for replacement bearings and the seal kit. When you notice your Neptune getting loud in the high speed spin cycle is when it is time to change your bearings. You don't want to wait too long to change them because the bearings will eventually fall apart and that will make it more difficult to get them out of there.
One last thing... If your Neptune front loader has the timer dial, you need to see if you have the faulty door latch wax motor. See Maytag Neptune wax motor for a video that explains the issue.
Until next time...
No comments:
Post a Comment