I have a Maytag front load Neptune MAH5500BWW problem

Q: Hi. I have the MAH5500B washing machine. My wife called in a panic and said the LCD panel displayed the LR code. I read 120V ac at the receptacle. I read 120V ac at terminals 1 and 3 on connector P6 at the machine control panel. I ran the Quick Service Cycle and everything seems to function except the tub does not spin. Checking across the 10 amp fuse on the motor control board yields 1 ohm resistance. I am thinking motor but I am not sure...any ideas? 

 A: Sure. You will have to replace the Motor control board and the motor with the new Maytag 12002039 motor conversion kit which may be available on ebay https://ebay.us/Aac7zW. If you already have the newer motor control board with plastic cover, you can try just replacing your motor control board. You can look at the photos on ebay and see if they look like your motor control board.

 

It takes about an hour to install. The original motor control boards have a high failure rate on the Neptunes so Maytag decided to redesign both the motor and motor control board. 

 Have you noticed your Neptune getting loud in spin cycle? If so, then your bearings are failing and will need to be replaced. The extra friction caused by the failing bearings can cause the motor control board to shutdown and/or fail. You can get new bearings and seal kit from www.neptunebearing.com. They also rent the special Neptune bearing tool to save you lots of time and effort and the rental incudes access to a video that shows you how to teardown machine, replace bearings using tool and install the seal kit. If you ask a service technician to come over you will receive a dose of sticker shock! They will quote you over $900 to quiet your machine again...

Until next time...

Hi Neptuners! Deep clean your Maytag Neptune with Affresh

Now you can deep clean your Maytag Neptune with Affresh!

Is your machine smelling less than fresh?

Try some Affresh today!

Recommended for all front loaders


Don't forget to check out the Neptune Help Song at www.neptunehelpsong.com for the cute Neptune song that explains the faulty door latch wax motor issue!

The Neptune Help Song voting is offically closed...

It looks like the new Neptune Help Song at http://www.neptunehelpsong.com/ is a winner!

Here are the results:

(22) folks say the song was awesome
(16) folks say the song was pretty good
(1) folks say the song was average
(0) folks say they were slightly impressed
(4) folks say they were not impressed

Honestly, I was disappointed with the total number of votes (43) as I expected more votes in the 3 week voting period considering that I have sold almost 4,000 12002535 wax motors in the last three years and there are 1,000's more Neptunes that will fail due to the faulty door latch wax motor.

We need to reach these Maytag Neptune owners before their wax motor fails so we can save them a $450 repair bill!

If you can think of anyone to send a link to that may have a Neptune or know someone who has a Neptune please do so... You can send them to http://www.neptunehelpsong.com/ so they can learn about the faulty door latch wax motor.

Thank you!

Another Maytag Neptune Question taken from the blogosphere...

Q: My Maytag Neptune quit mid-cycle. Trips circuit breaker every time plugged in. Is there a bypass to drain tub and open door? This seems like a catastrophic direct short. Should I wait a week for repairman or would it likely be more cost effective to buy new.

A: If you have an earlier MAH3000 Neptune then this more than likely is caused by a faulty wax motor in the soap dispenser. There are (2) 12002535 wax motors in there that control the bleach and softener flows. These wax motors are controlled directly from the timer.

You will need to rotate the timer to a different position, perhaps to a spin cycle, so the contacts to the faulty wax motor will open and the water pump should kick on and drain the water out. The water pump is also controlled by a set of contacts in the Neptune timer.

You can purchase the 12002535 wax motors from www.neptunehelp.com.

They have Maytag Neptunes over the pond?

Hi Neptuners,

I just shipped a STAGE 1 Q6 R11 repair kit + wax motor over the pond to New South Wales, Australia! I would like to welcome Andrew E. to the Neptuner club. We Neptuners all love our Neptunes... Especially, after the faulty door latch wax motor is replaced (hopefully you replaced it before it failed).

Did you know that Australia had Maytag Neptune front load washers? Actually, I was taken by surprise...

Recently, I shipped another STAGE 1 Q6 R11 repair kit + wax motor all the way to Israel.

Maybe I need to put flags on my http://www.neptunehelp.com/ site for countries that I ship the Maytag Neptune STAGE 1 repair kits too. So far, I have shipped STAGE 1 kits to United States, Canada, Israel and Australia.

Don’t forget to vote for the http://www.neptunehelpsong.com/ song. You only have 7 days left!

Jeff

What are they doing to that poor Maytag Neptune Front Loader?

What are they doing?

1. Winding up the spring to get the Neptune started?

2. Freeing the stuck tub?

3. Disecting the Neptune?

4. Adjusting the belt tension?

Actually, they are using the special Neptune Bearing Tool that can be borrowed at www.neptunebearing.com. The tool kit comes with the bearings, 12002022 seal kit and a DVD that shows you how to disassemble the Neptune front loader, replace bearings and install seal kit.

You don't have the use the tool kit... Folks have been changing their Neptune bearings using pipes, large hammer, threaded rod, large washers, patience, etc.

You can make replacing your Neptune bearings kid's play when using the Tony Tool.

The Maytag Neptune Help song is now online!

Hi Neptuners,

I finally finished the Neptune Help Song that explains the faulty door latch wax motor on the Maytag Neptune front loaders.

Every Neptune that has the original door latch wax motor, part 12002535, will fail eventually and burn Q6 and R11 on the machine control board. Now, my goal is to help Neptuners prevent the Q6 R11 failure by proactively replacing the faulty wax motor.

Also, I would like your feedback on what you think about the song. I have a poll on the top right where you can vote 1 -5, where 5 is awesome.

Your homework is to tell everyone about this song so we can help Neptuners all around the world replace the wax motor before it fails. Feel free to post links on your blogs and websites.

The new song is at www.neptunehelpsong.com.

Check it out...


Thank you,



Jeff